Kenwood LZ-760R - Manual (Page 9)

English | 9
< System Setup >
Setting the NAV input
Setup input and switch method of the navigation
picture.
Touch Setting
[ 7RGB] It becomes the RGB mode
setting. Operate the V.SEL
button when the image from
the navigation unit connected
to I/F terminal is shown on the
monitor.
[ 7AV-IN1] It becomes the AV-IN1 mode
setting. Operate the V.SEL
button when the image from
the navigation unit connected
to AV-IN1 terminal is shown on
the monitor.
[ 7Off] It becomes the Off mode
setting. Use this setting when
there’s nothing connected to
the I/F terminal.
Setting the AV-IN1 input
Setup switch method of the picture input to AV-IN
1 terminal.
Touch Setting
[ 7Video 1] It becomes the video mode
setting. Operate the V.SEL
button when the image from
the device connected to AV-
IN1 terminal is shown on the
monitor.
[ 7NAV] It becomes the navigation
mode setting. Operate the V.SEL
button when the image from
the navigation unit connected
to AV-IN1 terminal is shown on
the monitor.
[ 7Off] It becomes the Off mode
setting. Use this setting when
there’s nothing connected to
the AV-IN1 terminal.
Setting the AV-IN2 input
Setup switch method of the picture input to AV-IN
2 terminal.
Touch Setting
[ 7Auto] It becomes the auto video
mode setting. When the video
signal input to the AV-IN2
terminal, the monitor image is
switched to the image of the
device connected to the AV-IN2
terminal.
[ 7Manual] It becomes the video mode
setting. Operate the V.SEL
button when the image from
the device connected to AV-
IN2 terminal is shown on the
monitor.
[ 7Off] It becomes the Off mode
setting. Use this setting when
there’s nothing connected to
the AV-IN2 terminal.
System Setup Screen-1