Kenwood LZ-760R - Manual (Page 12)

Before Use
12 | English
< Touch Panel Adjustment >
Adjusting the Touch Position
The touch panel can be adjusted if the position
touched and the operation performed do not
match.
1 Accurately touch the mark at the lower left.
2 Accurately touch the mark at the upper right.
When the mark at the upper right is touched,
the adjustment is completed and the system
setup menu screen reappears.
• If the [Cancel] button is touched without touching the
button at the lower left, the adjustment is canceled and
the screen goes back to the Setup Menu Screen.
• If the [Cancel] button is touched after touching the
button at the lower left, the button at the lower left
reappears.
• If the [Reset] button is touched, the settings are reset
to the factory defaults and the setup menu screen
reappears.
Touch Panel Adjustment Screen
Setting the TV Area
(During the KTC-V500P is connected)
Select the area for TV broadcast viewing.
Selecting the Preset Bands:
Touch the [TV 1] or [TV 2] button.
Selecting the Reception Area:
Each time you touch the [ 2 ] or [ 3 ] button.
Select the channel setting for your country as
follows.
G1 China PAL-D
G2 Burnei
Malaysia
Singapore
Thailand PAL-B/G
G3 Hong Kong PAL-I
G4 Indonesia PAL-B/G
G5 Australia
• The reception area can be set for two separate preset
bands TV1 and TV2.
Exit the TV Area Setting Screen
Touch the [Return] button.
Return to the Setup menu screen.
• Pulling out the Connection cable to the TV tuner,
settings of the TV Area will be default. Press the Reset
button and set the TV Area again if the Connection
cable is reconnected.
TV Area Setting Screen