Kodak EKTAPRO - Manual (Page 5)

16
.
Connect your EKTAPRO Slide Projector
to the mains with the mains lead .
(UK users note: A suitable fused 13A plug
must be fitted. See instructions on cable!) .
Turn on the mains switch (10).
The projector is switched on and ready for
use. Lamp and fan are switched on.
Switching-on the projector
1.
Setting of a different operation voltage
Check voltage setting
Switching- on the
projector
2.
3.
EKTAPRO Slide Projectors will be exported throughout the world to countries with
differing mains voltages. The projectors are already set during manufacture to a fixed
mains voltage.
Shipments to countries with 220, 230 or 240 V mains will be equipped with a T 2A L/
250 V fuse. A spare fuse for replacement is also supplied.
Before you switch on your projector ensure that the voltage is correctly adjusted! An
incorrectly adjusted mains voltage can damage the projector! The voltage indicator
(12) must show your country´s actual mains voltage!
WARNING
For safety, the mains lead must be unplugged!
1.
Unlock the fuse link compartment (11) by using a screwdriver and pull
compartment out.
2.
Push the fuse link (13) into the compartment so -
3.
- that the applied voltage can be seen in the window (12) of the compartment.
.
Push the loaded compartment (with mounting underneath) firmly into the
projector opening provided.