Kenwood SIRIUS KTC-SR903 - Manual (Page 6)

— 6 —
English
You must have the Sirius ID number [ESN] for licensing with
Sirius Corp. Check the Sirius ID [ESN] of this unit as follows.
1 Select the Sirius Satellite Radio Mode
Press the [SRC] button.
Select the "SIRIUS" display.
2 Check the Sirius ID [ESN] of this unit
See the
Serial & Sirius ID [ESN]
It is especially important to retain the unit serial number and the
electronic Sirius Identification number for service activation and
potential future service changes.
Sirius ID [ESN] display
Listening to the satellite radio.
Press the [SRC] button.
Select the "SIRIUS" display.
• You need to subscribe to SIRIUS to receive the service by Sirius
Satellite Radio. Consult SIRIUS if "CALL 888-539 SIRIUS TO
SUBSCRIBE"/"CALL 888 539-SIRI" appears.
• It may take a little time to start receiving after you selected the
SIRIUS source.
• If the signal receiving fails, "Acquiring Signal"/"ACQUIRING
SIGNAL" appears.
Select Sirius Satellite Radio Mode
When you have the model-A control unit categorized by the
(page 5), follow the operation
instructions given below.
Press the [FM] button.
Each time the button is pressed the preset band switches
between the SR1, SR2, SR3 and SR4.
Selecting the Preset Band
Selecting the channel.
Press the [ 4] or [¢] button.
Tuning
Putting the channel in the memory.
1 Select the preset band
Press the [FM] button.
2 Select the channel to put in the memory
Press the [
4] or [¢] button.
3 Put the channel in the memory
Press the [1] — [6] button for at least 2 seconds.
The preset number display blinks 1 time.
On each band, 1 channel can be put in the memory on each [1]
— [6] button.
• Only the channel number is stored. Category information is not
stored.
• This function can be used only when the "Channel"/"CHANNEL"
has been selected in (page 7).
Channel Preset Memory
Operations from Model-A Control Unit
KTC-SR903(K)English 04.4.20 6:02 PM Page 6