Kenwood SIRIUS KTC-SR903 User Manual
Page 14
English
Operations from Model-D Control Unit
Entering the channel and tuning.
1
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote.
2
Enter the channel
Press the number buttons.
3
Do Channel Search
Press the [
4] or [¢] button.
Canceling Direct Access Tuning
Press the [DIRECT] button on the remote.
• If you make no button operation for 10 seconds, the Direct Access
Tuning mode is automatically canceled.
• You can set up to Channel number 223.
• You cannot search for a channel number which is not
broadcasting.
• If you cannot receive any signal in the input Channel due to a bad
condition on radio wave or another problem, "Acquiring Signal"
appears.
Direct Access Tuning
(Function of remote)
Select the category and channel you wish to listen to.
1
Enter category and channel search mode
Press the [2/6] button for at least 1 second.
2
Select the category
Press the [FM] or [AM] button.
3
Select the channel
Press the [
4] or [¢] button.
Canceling category and channel search mode
Press the [2/6] button.
• You cannot operate this unit until all the Category information is
acquired.
• Entering and canceling the category and channel search mode
with remote
Press the [
38] button on the remote.
Category and Channel Search
When you are listening to the Sirius satellite radio, you can
switch over the display information as follows.
For operations, see the
instruction manual of your control unit.
What is displayed may partly depend on control units to be
connected.
Information (Upper Part Display)
Band & Channel Number
Channel Name
Song Title
Artist Name
Category Name
Switching Display
Information (Lower Part Display)
Artist Name
Song Title
Channel Name
You cannot apply the same setting to Upper Part and Lower Part.
— 14 —
KTC-SR903(K)English 04.4.20 6:02 PM Page 14