Kenwood SIRIUS KTC-SR903 - Manual (Page 12)

— 12 —
English
Operations from Model-D Control Unit
You must have the Sirius ID number [ESN] for licensing with
Sirius Corp. Check the Sirius ID [ESN] of this unit as follows.
1 Select the Sirius Satellite Radio Mode
Press the [SRC] button.
Select the "SIRIUS" display.
2 Check the Sirius ID [ESN] of this unit
See the
Serial & Sirius ID [ESN]
It is especially important to retain the unit serial number and the
electronic Sirius Identification number for service activation and
potential future service changes.
Sirius ID [ESN] display
Listening to the satellite radio.
Press the [SRC] button.
Select the "SIRIUS" display.
• You need to subscribe to SIRIUS to receive the service by Sirius
Satellite Radio. Consult SIRIUS if "CALL 888-539 SIRIUS TO
SUBSCRIBE" appears.
• It may take a little time to start receiving after you selected the
SIRIUS source.
• If the signal receiving fails, "Acquiring Signal" appears.
Select Sirius Satellite Radio Mode
Press the [FM] button.
Each time the button is pressed the preset band switches
between the SR1, SR2, SR3 and SR4.
Selecting the Preset Band When you have the model-D control unit categorized by the
(page 5), follow the operation
instructions given below.
Selecting the channel.
Press the [ 4] or [¢] button.
Tuning
Calling up the channels in the memory.
1 Select the preset band
Press the [FM] button.
2 Call up the channel
Press the [1] — [4] button.
The channels are called up as shown below.
Press button Call up number
[1/5] No.1 No.5
[2/6] No.2 No.6
[3] No.3
[4] No.4
Each time the button is pressed, the called up channel switches
cyclically.
j
j
Preset Tuning
KTC-SR903(K)English 04.4.20 6:02 PM Page 12