Kidco G20 User Manual
Page 5
Screw hinge spindles (c) into top and bottom
rails of gate section (h) until they are exten-
ded equally. These will be adjusted to the
correct length at a later stage so do not
tighten.
Repeat process on gate section (i) using latch
spindles (m).
Mounting Locking Side
Screws provided are
for
mounting directly
into wood. If mounting into brick, drywall
or other surfaces, use appropriate hard-
ware. If installing into hardwood (i.e. oak),
drilling a pilot hole may be necessary.
Hold template (j) against mounting surface in
line with opposite hinges, making sure end
marked
is even with floor.
Mark 4 screw hole positions.
Remove template.
Determine which direction the gate should
open. For stairways, gate should never
open out over stairs.
Using 2 screws (q), screw bottom locking
bracket (p) into lower set of screw holes with
opening side facing direction gate will open.
Fit locking latch (k) into locking latch bracket
(l).
5