Kodak 8657 - Manual (Page 38)

Appendix C: About SCSI Connection
C-2 March 1998
6. Turn on the 8657 printer and when the printer is
ready, turn on the computer.
NOTE: If the New Hardware dialog box is displayed
by Windows 95 the first time your PC is
restarted, choose NEXT to let Windows
search for a driver. Then choose FINISH
after Windows is unable to find a driver. The
printer utilizes a Photoshop export module
rather than a SCSI driver.
7. For Windows NT 4.0 only, run the Adaptec EZ–SCSI
software install program to install the software on
your system.
Instructions for installation are included in the
Adaptec EZ-SCSI User’s Manual.
Macintosh Systems
To connect the 8657 printer directly to your Macintosh
computer (or to daisy-chain the printer with an external
SCSI device), perform the following steps.
IMPORTANT: If you are using a Macintosh IIfx computer,
you must install a special terminator
provided by Apple Computer; or
unpredictable results can occur.
1. Set the SCSI device number using the 8657 printer’s
display panel.
The printer is set at the factory for SCSI ID 5. If you
need to change the SCSI ID, refer to the user’s guide
for the Kodak Professional 8657 thermal printer for
instructions about setting the SCSI device number.
2. Turn off all equipment before plugging or unplugging
equipment on the SCSI bus.
3. Attach a SCSI cable appropriate to your equipment’s
configuration.
4. Attach the SCSI terminator.