Kenwood KDC-MP6029 - Manual (Page 9)

English | 9
Adjustment Item Display Range
Front High Pass
Filter *
2
"HPF" Through/80/100/120/150
/180 Hz
Rear High Pass
Filter *
2
"HPR" Through/80/100/120/150
/180 Hz
Low Pass Filter* 1 * 2 "LPF" 60/80/120/Through Hz
Subwoofer Phase* 1 * 2 "PHAS" Reverse (180°) / Normal (0°)
Volume offset "V-OFF" –8 — ±0
Loudness "LOUD" ON/OFF
• Volume offset: Each source’s volume can be set as a
difference from the basic volume.
• Loudness: Compensating for low and high tones
during low volume.
• * 1 You can control this item when
Output> (page 9) is set to "SW ON".
• * 2 Function of the KDC-MP6029
5 Exit Audio Setup mode
Press [VOL] knob for at least 1 second.
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1 Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2 Enter Speaker Setting mode
Press the [VOL] knob.
3 Select the Speaker type
Turn the [VOL] knob.
Each time the knob is turned, the setting
switches as shown below.
Speaker type Display
OFF "SP OFF"
For 5 & 4 in. speaker "SP 5/4"
For 6 & 6x9 in. speaker "SP 6*9/6"
For the OEM speaker "SP OEM"
4 Exit Speaker Setting mode
Press the [VOL] knob.
Function of the KDC-MP6029
Subwoofer Output
Turning the Subwoofer output ON or OFF.
Hold down on [AM] of the Control knob for at
least 1 second.
Each time the button is pressed, Subwoofer
output switches ON and OFF.
When it’s ON, "SW ON" is displayed.