KORG M50 - Manual (Page 23)

20
Editor operations
1
Select Program mode, and click the Editor Pages [PLAY] tab to access the Play page.
2
At the left side of the control surface located at the top of the screen, click the [RTC]
selector, and choose A for the A/B selector below it.
The indications of the four knobs will be [CUTOFF], [RESONANCE], [EG
INTENSITY], and [EG RELEASE].
3
In the set of tabs located in the center of the screen, choose [OSC Mixer/ARP].
4
Use the four knobs of the control surface to vary the sound. Using the mouse to move the
on-screen knobs will have the same result as turning the four knobs on the M50 itself.
For an explanation of these parameters, please refer to the M50 parameter guide (PDF).
5
Next, choose the [ARP] selector located to the left of the control surface so that you can
control the arpeggiator
.
Now the four knobs will control the arpeggiator.
6
To the left of the control assign selectors, turn on the ARP ON/OFF button and DRUM
ON/OFF button, and play the keyboard; a performance generated by the arpeggio function
and the drum track will begin playing. To change the drum pattern that is playing, change
the Pattern No.
on the Basic/Drum Track page. To change the arpeggio pattern, change the
Pattern on the Basic/ARP page.
7
While letting the arpeggiator play, move the four knobs or the knobs of the M50 itself, and
notice how the arpeggio changes.
8
The upper part of the Play page shows the current values of the most important parameters
for Program mode. This overview area shows the parameters organized by section. By
clicking a section name (such as “Pitch EG” or “Filter1 EG”) you can jump automatically
to the page/tab for editing the corresponding parameters.