Kenwood DPF-2030 - Manual (Page 18)

18
The following procedure allows to record a CD within the
specified tape length so that no music is interrupted in the
middle at the ends of sides A and B.
Editing
Preparation
: Keys and control used in the operations described on this page.
1
Light the “EDIT” indicator.
2
Go to step
2
within 5 seconds.
If more than 5 seconds have elapsed,
press the key again.
Blinks.
Lights up. Lights up.
Enter the recording time of the tape.
The CD contents are edited as follows.
(1) The tape recording time input is divided by two, and tracks that can
be accommodated in file A (which refers to tracks on tape side A) are
selected in order of their track Nos.
(2) In a few seconds, the time left on tape side A is displayed, then file
B (tracks on tape side B) is edited in the same manner.
÷ The EDIT function may not operate properly for discs having only one
track or having tracks of long duration such as classical music.
(
“no FILE” is displayed.)
Press the 6 key to start playback according to the edited content. The
playback pauses at the beginning of the track edited for tape side B. Press
the 6 key again to continue playback.
When recording the edited content onto a tape, it is recommended to
use the synchro recording or
CCRS recording function of KENWOOD
cassette decks.
÷ Do not adjust the output level from this unit particularly during record-
ing.
÷ For details, see the instruction manual of the cassette deck.
Playing or recording the edited contents
÷ Load a disc in the CD player. @
÷ Press the stop (7) key to set the unit in the
stop mode.
÷ Make sure the PGM indicator is extinguished.
$
0 7 6
4 ¢
1 ¡
0
EDIT
TRACK
EDIT
6
1
7
2
8
3
9
4
10
5
PGM
C _ _ _
REMOTE CONTROL UNIT RC-P0715
1 2 3
4 5 6
7 8 9
0 +10
Press the numeric keys as shown below.
30-minute tape : 000)
46-minute tape : 00006
Main unit
(Except for DPF-2030)
Remote control unit
(Except for DPF-1030)
TIME DISPLAY
0
÷ By pressing the TIME DISPLAY key the set time-length intervals
will change in this order;
÷ The interval length can be adjusted with the skip keys (4,¢)
in units of one minute (to a maximum of 99 minutes).
¢ : increase by one minute.
4 : decrease by one minute.
3
Press the EDIT key once again.
(Except for DPF-2030)
0
EDIT
÷ When the interval length has been set using the numeric keys, the EDIT
key does not have to be pressed after the interval has been set.
The figure shows an example for the DPF-2030
÷ Recording within 99 minutes can be specified in minutes (2 digits).
÷ While you can edit with a different time setting to that of the tape you are using, part of the tape may be left with nothing recorded on it, or the last
track on side A or side B may be cut short.
Go to step 3 within 5 seconds.