Kenwood DPF-2030 - Manual (Page 14)

14
Programmed play (PGM mode)
Use the following procedure to program desired tracks in a
desired order. (up to 20 tracks)
÷ Load a disc in the CD player. @
Press so that the “PGM” indicator lights.
Program desired tracks.
1
2
Preparation
: Keys and control used in the operations described on this page.
÷ The programmed contents remain in memory.
To stop playback
Start playback.
3
÷ When the 4 or ¢ key is pressed during playback, the track will be
skipped in the direction of the pressed button.
÷ When the 4 key is pressed once during playback, the play position
returns to the beginning of the current track being played.
Lights up.
Displays the total playing time
of the programmed tracks.
÷ Up to 20 tracks can be programmed. When “FULL” is displayed, no
more tracks can be programmed.
÷ If you make a mistake, press the CLEAR key and enter the track No.
from the beginning.
÷ When the total playing time of the programmed tracks exceeds 100
minutes, the remaining time on the disc will not be displayed any more.
2
Set the entry.
1
Select the desired track No.
Press the numeric keys as
shown below....
To enter track No. 15:
05
Go to step 2 within 5 seconds.
3
Repeat steps 1 and 2 above.
Do this operation in the stop mode.
Displays the entered program No.
for a few seconds.
0 7 6
4 ¢
1 ¡
0
0
0
0
TRACK
NO. PGM
0 1
TRACK
NO.
0 2
P _ 0 1
TRACK
NO. TOTAL TIME
0
_ :
2
1 6 4 2
1 2 3
4 5 6
7 8 9
0 +10
7
6
P.MODE
P.MODE
Go to step 2 within 5 seconds.
4 ¢
Main unit
(Except for DPF-2030)
Remote control unit
(Except for DPF-1030)
The figure shows an example for the DPF-2030
(Programming is not
possible during playback)