Kenwood DPC-X937 - Manual (Page 38)

38
DEUTSCH
IT
ALIANO
ESP
AÑOL
Listening through the speakers on the recharger stand (DPC-X937/DPC-X637 only)
Before using the recharger stand, be sure to read "Preparation of the recharger stand". (Page 12)
4
Adjust the volume.
2
Place the main unit on
the recharger stand by
aligning the triangular
markings on them.
1
Turn the main unit OFF.
÷ In certain sound modes, the audio may be distorted
when the volume is set too high. In this case, select
another sound mode or lower the volume.
÷ The operation tone (beep) and alarm tone are not
mixed in the speaker audio.
Main unit Remote control
Main unit Remote control
÷ If the main unit is placed on the recharger stand im-
mediately after the main unit is removed from it, the
main unit may malfunction (beginning or ending play-
back unintentionally). After the main unit is removed
from the recharger stand, wait for at least 3 seconds
before placing the main unit again.
3
Start playback.
Main unit Remote control
Goes off
*5378_25_38EN 03.7.3, 3:13 PM 38