Kenwood KDC-U6046L - Manual (Page 13)

English | 13
Tuner Operation
Station Preset Memory
Putting a station in the memory.
1 Select the frequency to put in the memory
Push the Control knob towards right or left.
2 Enter Preset Memory mode
Press the [ ] button.
3 Preset the station
Turn the Control knob to select preset number
(“P1” – “P6”), and then press the [ENTER] button
for at least 2 seconds.
Cancelling the Preset Memory mode
Press the [ ] button.
Preset Tuning
Recalling the stations in the memory.
1 Enter Preset Tuning mode
Press the [ ] button.
2 Recall the station
Turn the Control knob to select recall number
(“P1” – “P6”), and then press the [ENTER].
Cancelling Preset Tuning
Press the [ ] button.
Function of remote control
Direct Access Tuning
Entering the frequency and tuning.
1 Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
“– – – –” is displayed.
2 Enter the frequency
Press the number buttons on the remote
control.
Example:
Desired frequency Press button
92.1 MHz (FM) [9], [2], [1]
810 kHz (AM) [8], [1], [0]
3 Search the frequency
Press the [ 4] or [¢] button on the remote
control.
Cancelling Direct Music Search
Press the [ ] button on the remote control.
⁄
• You can enter the FM band frequency in steps of a
minimum of 0.1 MHz.
Frequency Step Setting
Changing the tuning frequency step.
The original setting is FM band 50 kHz, and AM
band 9 kHz.
1 Turn the power OFF
Press the [SRC] button for at least 1 second.
2 Switch the frequency step
While pressing the [FAVORITE] button and
[ENTER] button, press the [SRC] button.
Release your fingers from the button after the
display appears.
The frequency step changes to FM band 200 kHz,
and AM band 10 kHz.
⁄
• When the same operation is repeated, the frequency step
returns to the original setting.
• When the frequency step is changed, the frequencies in the
memory are deleted.