Kenwood KDC-PS909 - Manual (Page 38)

— 38 —
English
Troubleshooting Guide
SOLUTION POSSIBLE CAUSE PROBLEM
A CD ejects as soon as it is
loaded. The CD is upside-down. Load the CD with the labelled side up.
The CD is quite dirty. Clean the CD, referring to the section on "Cleaning CDs" (see
page 5).
The sound skips on a CD. The CD is scratched or dirty. Clean the CD, referring to the section on "Cleaning CDs" (see
page 5).
The specified track does not
play. Random play has been selected. Turn off the random play function.
Disc Changer
SOLUTION POSSIBLE CAUSE PROBLEM
The computer chip in the unit is not functioning normally. Press the reset button on the unit (see page 4).
The disc changer mode cannot
be selected. No cable has been connected to the disc changer input
terminal on the unit. Connect the cable to the disc changer input terminal on the
unit.
The specified disc does not
play, but another one plays
instead. The specified CD is very dirty. Clean the CD.
The CD is upside-down. Load the CD with the labelled side up.
The disc is loaded in a different slot from that specified. Eject the disc magazine and check the number for the
specified disc.
The disc is severely scratched. Try another disc instead.
The sound skips. Something is touching the disc changer. Remove whatever is touching it.
The CD is scratched or dirty. If skipping happens at the same place when the car is
stopped, something is wrong with the CD. Clean the CD.
The display shows that the
changer is being played, but no
sound can be heard.
The specified track does not
play. Random play or magazine random play has been selected. Turn off the random play or magazine random play function.
The O-N selection switch of the disc changer is not set
properly. Set the O-N selection switch to "O" position.