Kenwood KRF-V5300D - Manual (Page 37)

English
37
Remote control unit
Symptom Cause Remedy
Remote control operation is not possible. The remote control is set to the DVD player operation
mode. Press any of the Input Source keys to select the
appropriate operation mode.
Batteries are exhausted. Replace with new batteries.
The remote control unit is too far away from the main
system, controlling angle is too large, or there is an
obstacle between this unit and the remote. Operate the remote control unit within the controllable
range.
7
The remote control has not been changed to the operation
mode for the Kenwood DVD player you wish to control. Press the [CD/DVD] or [DVD/6CH] key to activate the
operation mode for the component you want to control
before operation.
Resetting the Microcomputer Resetting the Microcomputer
The microcomputer may malfunction (unit cannot be operated,
or shows an erroneous display) if the power cord is unplugged
while the power is ON, or due to some other external factor.
If this happens, execute the following procedure to reset the
microcomputer and return the unit to its normal operating
condition.
While holding down [ ] key on the unit, unplug the
power cord and plug it back in.
• Please note that resetting the microcomputer will clear the
contents of the memory and return the unit to the state it was in
when it left the factory.
Memory back up function Memory back up function
Please note that the following items will be deleted from the
unit's memory if the power cord is disconnected from the AC
outlet for approximately 1 day.
• Input selector settings
• Volume level
• BASS, TREBLE, INPUT level
• TONE ON/OFF
• ACTIVE EQ mode
• Dimmer level
• Speaker settings
• Sound Adjustment (Input level, Midnight
mode, Panorama mode, Dimension mode,
Center Width mode)
• Listen mode setting
• Tuner setting
In regard to contact cleaner In regard to contact cleaner
Do not use contact cleaners because it could cause a malfunction.
Be specially careful not to use contact cleaners containing oil, for
they may deform the plastic component.
Maintenance of the unit Maintenance of the unit
When the front panel or case becomes dirty, wipe with a soft, dry
cloth. Do not use thinner, benzine, alcohol, etc. for these agents
may cause discoloration.