Kenwood MDX-G2 - Manual (Page 44)

44 EN
To cancel O.T.T. timer :
Perform steps 1 to 3 and select “TIMER
OFF” and “O.T.T.” will disappear.
To check or change the timer setting :
Restart the procedure from step 1 again.
÷ Be sure to adjust the time of the day (page
7) before using the timer functions.
÷ When the STANDBY/TIMER indicator is blink-
ing in green, the timer setting or clock set-
ting is erroneous. Check and correct them
as required (pages 7 & 43 to 44).
÷ The O.T.T. timer cannot be used for program
playback of CD or MD.
÷ Even when the O.T.T. timer is canceled, pre-
viously made setting is stored in memory and
remains until new timer information is set
the next time.
7
Press the VOLUME/ MULTI CON-
TROL keys to adjust the listening
volume.
The source will be played at the ad-
justed volume.
8
Press the ON/STANDBY key
(or POWER key on the remote
control) to switch the power off
to the STANDBY mode.
The STANDBY/TIMER indicator lights
green.
The O.T.T. timer is activated and play-
back will start when the set ON time
comes.
*5052/43-49/EN 5/29/01, 10:40 AM 44