Kodak Digital Science DC120 - Manual (Page 17)

2-7
2
Using Camera
Flash
The DC120 is equipped with a built-in sensor flash with three settings:
☞
The Auto flash setting will not respond when using a Manual Exposure
shutter speed of 1/250 to 1/500 seconds. Set the flash to Fill if a flash is
needed at those shutter speeds.
The flash has an effective range of approximately:
✔
2.3 to 16.4 ft. (0.7 to 5 m) using the Wide Angle setting
✔
2.3 to 10.8 ft. (0.7 to 3.3 m) using the TelePhoto setting
To change the Flash setting:
1 Turn the camera on and press the TAB button four times.
The Flash icon blinks.
2 Press the SELECT button to scroll through the Flash settings.
3 Press the ENTER button to select the appropriate Flash setting.
The Flash icon is changed to the selected Flash setting.
The selected Flash setting returns to the default setting when the camera is turned
off.
☞
An external flash may be used with an optional Flash Sync cable.
Auto— flash fires automatically whenever the Shutter button is pressed
and the DC120 determines that there is not enough light to take a
picture. This is the default setting.
Fill— flash fires every time you press the Shutter button. Use this setting
when the lighting is poor or when your subject is lit from behind.
Off— flash is turned off and will not fire.
A
A
A