Installation – Kenwood KDC-507 EN User Manual
Page 33
— 33 —
Installation
Make sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (eg, the sound may skip).
Bend the tabs of the
mounting sleeve
with a screwdriver or
similar utensil and
attach it in place.
Metal mounting
strap
(commercially
available)
Self-tapping
screw
(commercially
available)
Firewall or metal support
■ Installation
Screw (M4X8)
(commercially
available)
■ Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main unit so that it
does not fall off.
1
Refer to the section
34) and then remove the hard rubber frame.
2
Drop open the faceplate by pressing the Release button.
Never insert the screws in any other screw hole than the one specified.
If you screw them in another hole, it will contact and may cause
damage to the mechanical parts inside the unit.
4
Tighten the screws (ш2 Ч 4 mm) (Accessory
5
) in the holes
shown on the diagram.
Accessory6
5
Tighten the screws (ш2 Ч 6 mm) (Accessory
6
) in the holes
shown on the diagram.
Accessory5
3
Tighten the screws (ш2.6 Ч 12 mm) (Accessory
4
) in the holes
shown on the diagram.
Accessory4
KDC-M6024G_U.S r4 02.11.8 9:22 AM Page 33