Kenwood KDC-507 EN - Manual (Page 25)

A red indicator will blink on the unit after the faceplate is
removed, warning potential thieves.
Display Setting
"DSI ON" LED flashes.
"DSI OFF" LED OFF.
DSI (Disabled System Indicator)
Synchronizing the RDS station time data and this unit's clock.
Display Setting
"SYNC ON" Synchronizes the time.
"SYNC OFF" Adjust the time manually.
It takes 3 to 4 minutes to synchronize the clock.
Synchronize Clock
3 Adjust the hours
Press the [FM] or [AM] button.
Adjust the minutes
Press the [
4] or [¢] button.
4 Exit Clock adjustment mode
Press the [MENU] button.
This adjustment can be done when the (page
25) is set as OFF.
1 Select Clock Adjustment mode
Press the [FM] or [AM] button.
Select the "Clock Adjust"/ "CLK ADJ" display.
2 Enter Clock Adjust mode
Press the [
4] or [¢] button for at least 1 second.
The clock display blinks.
Manual Clock Adjustment
Setting the operation check sound (beep sound) ON/OFF.
Display Setting
"Beep ON"/ "BEEP ON" Beep is heard.
"Beep OFF"/ "BEEP OFF" Beep canceled.
Touch Sensor Tone
"APPROVED" is displayed.
The unit can be used.
If an incorrect code is input, "WAITING" is displayed, and the input
prohibited time shown below is generated.
After the input prohibited time lapses, "CODE" is displayed, and
input can be done.
Number of times Input prohibited time
the incorrect code was input
1 —
2 5 minutes
3 1 hour
4 24 hours
— 25 —
KDC-M6024G_U.S r4 02.11.8 9:22 AM Page 25