Kenwood KDC-MP858 - Manual (Page 11)

English | 11
Display Mode Switching
Switching the display mode.
1 Enter display Control mode
Press the [DISP] button.
"Display Control" is displayed.
2 Select the Display mode
Press the [ 4] button.
Each time the button is pressed the display
switches as shown below.
Display Mode Display
"Display Type A"
1
2 3 3
"Display Type B"
1
2
"Display Type C"
4 3 3
1 Upper text display part
2 Lower text display part
3 Level meter display part
4 Demonstration
• You can display the information that will be shown
in the Upper text display part, the Lower text display
part or the Level meter display part according to the
setting of Display mode. Refer to the following pages
for how to select the mode.
DisplayA DisplayB DisplayC
Upper page 12 page 12 —
Lower page 12 page 12 —
Level page 13 — page 13
3 Exit Display Control mode
Press the [DISP] button.
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1 Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2 Enter Speaker Setting mode
Press the [Q] button.
"Speaker Setting" is displayed.
3 Select the Speaker type
Press the [ 4] or [¢] button.
Each time the button is pressed the setting
switches as shown below.
Speaker type Display
OFF "Speaker OFF"
For 5 & 4 in. speaker "Speaker 5/4inch."
For 6 & 6x9 in. speaker "Speaker 6*9/6inch"
For the OEM speaker "Speaker O.E.M."
4 Exit Speaker Setting mode
Press the [Q] button.