Kenwood TM-D700A - Manual (Page 67)

61
12
■ Selecting TX Speed
Some repeaters may not respond correctly if a DTMF
number is transmitted at fast speed. If this happens,
change the DTMF number transmission speed from
Fast (default) to Slow.
In Menu mode, access Menu 1–5–2 (TX SPEED) and
select “Slow”.
■ Selecting Pause Duration
You can also change pause duration stored in
memory channels; the default is 500 msec.
In Menu mode, access Menu 1–5–3 (PAUSE) and
select from 100, 250, 500, 750, 1000, 1500, and 2000
msec.
■ Transmitting a Stored DTMF Number
1 Press Mic [PTT]+ Mic [PF].
2 Release only Mic [PF], then press Mic [UP]/
[DWN] to select the desired DTMF memory
channel.
3 While still holding Mic [PTT], press [0] to [9]
corresponding to the channel number.
• The number stored in the channel scrolls across the
display accompanied by DTMF tones from the
speaker.
• After transmission, the frequency display is restored.