Kathrein UFD 170 - Manual (Page 16)

Initial Setup
16
Getting Started
Connect the unit to the power supply. Turn on the receiver using the
power switch on the front. The unit is then in standby mode.
Turn on the receiver with the

key on the remote control.
Your UFD 170 welcomes you. The following OSD then appears:
The turntable then searches for the factory-preset programme.
In this case, this is “Das Erste” on the ASTRA satellite. The following
message then appears:
Before setting up the system, make sure that it has been mounted,
installed and connected properly, as described in the installation
manual and the safety instructions.
Important Information
Press the

key to start the search.