Konica Minolta PagePro 1380 MF - Manual (Page 30)

Media storage 32
Media storage
How do I store media?
„ Keep media on a flat, level surface in its original wrapper until it is time to
load it.
Media that has been stored for a long time out of its packaging may dry up
too much and cause misfeeding.
„ If media has been removed from its wrapper, place it in its original pack-
aging and store in a cool, dark place on a level surface.
„ Avoid moisture, excessive humidity, direct sunlight, excessive heat (above
35°C [95°F]), and dust
„ Avoid leaning against other objects or placing it in an upright position.
Before using stored media, do a trial print and check print quality.
Loading media
How do I load media?
Take off the top and bottom sheets of a
ream of paper. Holding a stack of approx-
imately 200 sheets at a time, fan the
stack to prevent static buildup before
inserting it in a tray.
"
Do not fan transparencies.
Note
Although this machine was designed for printing on a wide range of
media types, it is not intended to print exclusively on a single media
type except plain paper. Continuous printing on media other than plain
paper (such as envelopes, thick stock, or transparencies) may
adversely affect print quality or reduce engine life.
When refilling media, first remove any media remaining in the tray. Stack it
with the new media, even the edges, then reload it.
Do not mix media of different types and sizes, as this will cause media mis-
feeds.