SMC Networks Wireless Broadband Router - Manual (Page 8)

-7-
2.1.2. Rear Panel
The rear panel features three 10/100 Mbps Ethernet ports and one Wide Area
network (WAN) port. The WAN port connects your DSL or cable modem to the router.
The LAN ports are used to connect to your computers or other network devices.
Figure 2-2 Rear Panel
Ports:
Port Description
RESET
To reset system settings to factory defaults, please follow the steps:
1. Power off the device,
2. Press the reset button and hold,
3. Power on the device,
4. Keep the button pressed about 5 seconds,
5. Release the button,
6. Watch the M1 and M2 LEDs, they will flash 8 times and then M1 flashes
once per second.
PRINTER Printer Port (Optional)
COM Serial port (connect dial-up modem or console cable)
WAN Port The port where you will connect your cable (or DSL) modem or Ethernet
router.
Port 1-3 The ports where you will connect networked computers and other devices.
DC IN Power inlet (DC 12V)