Attach to your network using ethernet cabling, Attach to your network using ethernet cabling -7, Internet – SMC Networks Barricade SMC7004AWBR User Manual
Page 27
I
NSTALLATION
2-7
3. Connect your printer: Use standard parallel printer cable to
connect your printer to the printer port on the Wireless Barricade.
4. Power on: Connect the power adapter to the Wireless Barricade.
Figure 2-2. Connecting the Wireless Barricade
Attach to Your Network Using Ethernet Cabling
The three LAN ports on the Wireless Barricade can auto-negotiate
the connection speed to 10 Mbps Ethernet or 100 Mbps Fast
Ethernet, as well as the transmission mode to half-duplex or
full-duplex. These LAN ports also support auto-configuration for
pin signals (auto-MDI/MDI-X) that allows you to use
straight-through cable for connecting the Wireless Barricade to any
network device. (See Appendix B for details on wiring.)
Use twisted-pair cable to connect any of the three LAN ports on
the Wireless Barricade to an Ethernet adapter on your PC.
Otherwise, you can cascade any of LAN ports on the Wireless
Barricade to an Ethernet hub or switch, and then connect your PC
or other network equipment to the hub or switch. When inserting
an RJ-45 plug, be sure the tab on the plug clicks into position to
ensure that it is properly seated.
Internet
Internet
Access
Device
SMC7004AWBR
Wireless Broadband Router
SOHO Office or Residence
SMC7004A
WBR
LAN 1
PWR
WLAN
WAN
2
3
Link
Activity
Notebook with
Wireless PC Card