Simrad Autopilot AP26 - Manual (Page 109)

Maintenance
20221586B
107
Autotrim standard value is 40 sec. which should work well on
most boats.
Rudder Limit should be kept at 20 degrees unless there is a
need for more rudder when performing dockside manoeuvres.
Recall Autotuned?
To recall the parameter values
that were achieved during the
Automatic tuning procedure,
rotate the course knob
clockwise. When parameter
values are recalled, Confirmed
is displayed.
Exit the Parameter menu by pressing STBD button to proceed to
the Service menu, or press STBY to return to normal autopilot
operation.
4.9 Service Menu
Select STANDBY mode and then enter the Installation Menu by
pressing and holding the NAV/WIND/SETUP button for 5
seconds. Select "Service by pressing the STBD button and
confirm by rotating the course knob clockwise.
System data and
SimNet/NMEA data are test
functions to analyze data
processed by the autopilot.
To exit the menu, press any
mode key (STBY, AUTO or
NAV).
Correct setting of counter
rudder, ideal response
New course