SkyGolf SkyCaddie SGX - Manual (Page 4)

4
• Hole: During play, press the Hole Button to manually advance to a different hole
than the one you are on. If Auto-Hole Advance is turned on, you will not need
to press this button to go to the next hole, since the SGX will know to change
holes automatically. Choose to select that hole or advance to a different hole by
scrolling through the list of holes using the Joystick.
• Mark Ball: The SGX’s Mark Ball feature calculates your shot distance. This feature
is useful in determining how far you typically hit each club in your bag, leading to
better club selections and an overall improvement in course management. To use,
press the Mark Ball Button, then select “Mark” before taking your shot. Press the
Mark button again when you get to the location where your ball landed. The shot
distance will be displayed. Mark Ball is discussed later in this guide, in Chapter 4.
1.1.4 On-Screen Indicators
• Battery Gauge: Displays the SGX’s remaining battery level.
• Digital Clock: Displays the current time, based on the signal that the SGX receives from the satellites.
• Satellite Signal Indicator: Shows real-time GPS satellite signal strength. The plus sign (+) above the signal
bars indicates that SBAS (Satellite-Based Augmentation System) has been acquired. This is the preferred
signal level for optimal performance.
1.2 System Requirements
Before registering and activating your SGX with SkyGolf using the free CaddieSync desktop software, please
make sure your computer meets the minimum system requirements:
• PC with Windows® XP/Vista/7 (32- or 64-bit) — OR —
• Mac OS
® 10.5 or higher, Intel ® or PowerPC ® processor
• 512 MB of RAM (1 GB of RAM recommended)
• 25 MB of available hard disk space
• Available USB 1.1 or 2.0 port
• Internet access (High-speed recommended)
• Microsoft
® Internet Explorer ® 7.0 or later (recommended)
• Safari ® 4.0 or later (Mac)
1.3 Charging Your SGX
We recommend charging the SGX each time before playing a round. The battery should hold a single charge
for up to 14 hours of continuous play. If the battery level is low, a full recharge may take up to 4 hours.
Charging Your SGX Using a Wall Outlet
1. Gently pull back the rubber cover located on the upper left side of the SGX to
gain access to the Micro-USB Port. Using the cable included in the box, insert
the micro-USB connector (small end) into the open port.
2. Take the other end of the cable (the USB connector) and insert it into the power
adapter that is included in the box.
3. Plug the power adapter into an open wall outlet or surge protector.
4. The SGX’s display will turn on and display the Sync screen. Select “Charge” using
the Right Key to see the Battery Charging screen. After 10 seconds, this screen
will fade out and the device will be in a hiberation mode while it is charging,
unless you select “Exit” in order to use the SGX while it is charging. There is
not a charging indicator light on the device itself.
Charging Your SGX Using Your Computer
Your SGX will recharge when it is connected to a computer that is powered on. With the SGX powered off,
connect the micro-USB end of the cable into the SGX, then plug in the USB end into an open port on your
computer. Your SGX will power on and recharge through this connection. Please do not turn off the SGX
while it is charging.
IMPORTANT!
When charging the SGX for the
first time, please use a wall outlet
instead of your computer. DO NOT
sync your SGX to a computer prior to
installing Caddiesync.
DO NOT power the SGX off
while it is charging. Keeping the
device ON so that it may
recharge in a timely manner.
Hole selection screen
Have a New Computer?
If you recently purchased a new PC
or Mac (within the last year or so),
it should be compatible with the
SkyCaddie SGX system.
C o m p a t i b l e w i t h
PC and Mac ®
Battery Charging
screen