Sharp 36F630 - Manual (Page 42)

42
Dimension: 140 X 215 mm
Operation of Universal Remote Control (Continued)
• How to identify a VCR
The remote control may already be set to
operate your VCR. Try this initial check before
going on to the following “identifying” section.
(1) Press TV/VCR button.
(2) Point the Remote towards VCR and press
POWER (DVD/VCR).
(3) Does the Remote turn the VCR ON and OFF?
• If yes, the Remote is ready to operate the VCR
and no further steps are needed.
• If no, continue to the “identifying” section.
Direct Entry Method
Refer to the following steps and list to quickly
find the remote control code for your accessory
VCR.
• First look up your VCR’s remote control code
number before going through the Direct Entry
Method.
• If this procedure does not identify your
accessory VCR, use the Search Method of
identification (described in the next section).
(1) Press TV/VCR button.
(2) Press and hold down DISPLAY and CH
s on
your remote control.
Then release both buttons.
(3) Within 10 seconds after releasing DISPLAY
and CH s , enter your VCR’s two-digit remote
control code number using the REMOTE
KEYPAD (refer to the list on page 43).
• The remote control is now ready to send
commands to your VCR.
Some brands have more than one remote code
listed, due to changes in the remote codes
from early to later model years, or due to format
differences (VHS/BETA). In such cases, you
may have to try more than one code to find
the code your VCR accepts.
Note:
Depending on the model, year produced,
brand, and type of VCR, some models may
not be compatible with the remote control.
Search Method
(1) Press TV/VCR button.
(2) Press POWER of the VCR to ON.
(3) Stand at least 6 feet away from the front of the
VCR.
Point the Remote towards the VCR.
Hold down DISPLAY and CH
a at the same
time. KEEP HOLDING THE BUTTONS
DOWN.
(4) Watch the Channel Number indicator on the
VCR, Channel numbers will scan up when the
VCR has been identified.
Release DISPLAY and CH
a as soon as the
channel numbers start to scan up.
The VCR’s remote control code number has
been identified, and the Remote is ready to
operate the VCR.
POWER
(DVD/VCR)
DISPLAY
CHANNEL
UP (
a)/
DOWN ( s)
CATV/DVD-TV/VCR
REMOTE
KEYPAD
TV
POWER
36F630(41-43) 03.3.5, 3:07 PM 42