Sanyo PJLINK PDG-DXL100 - Manual (Page 60)

English
59
English
Appendices
Use of Telnet
You can control the projector by using the telnet application
installed on your computer. Normally, the telnet application
is available on your computer.
 The telnet 10000 port
is used to control the
projector.
 Further instructions
about the telnet ap-
plication, please see the
on-line guide on your
computer.
Note
Control
(For example, in case of using the telnet application of Windows XP
Professional.)
1. Select Run... submenu from Start menu on the computer. Type
“telnet” onto the Open text area on the displayed window and press
OK button.
2. The telnet application will start and the following window will be
displayed. Type as below to connect the projector.
> open 192.168.1.201 10000 [return]
* Use the IP address assigned to the projector.
3. When communication is established correctly, the word “PASS-
WORD:” appears on the window. Type the login telnet password
for the projector and then press “Enter” key on the keyboard. If you
do not set up the telnet password, just press “Enter” key. When the
word “Hello” is replied, login has been succeeded.
* The password “1234” is used for the example.