Sanyo PJLINK PDG-DXL100 - Manual (Page 11)

10
English
Introduction
5 MENU Press “MENU” to launch the On-
screen display (OSD), back to the top
level of OSD for the OSD main menu
operation
6 IMAGE Select the Image mode from Presenta-
tion, Movie, sRGB, Bright and User.
7 INPUT Press “INPUT” to choose RGB,
SCART, Component, S-Video, Com-
posite and HDMI sources.
8 D.ZOOM - Zoom out the projector display.
9 KEYSTONE
+/-
Adjust the image to compensate for
distortion caused by tilting the projec-
tor.
10 LAMP CON-
TROL
Select the lamp mode. (refer “ECO
Mode” function )
11 AV-MUTE Momentarily turn off/on the audio
and video.
12 COMPUTER 1 Press “COMPUTER 1” to choose
Computer in 1/Component in 1 con-
nector.
13 COMPUTER 2 Press “COMPUTER 2” to choose
Computer in 2/Component in 2 con-
nector.
14 FREEZE Pause the screen image. Press again to
resume the screen image.
15 Four
Directional
Select Keys
Use or or or to select items or
make adjustments to your selection.
16 ASPECT Display the “Aspect Ratio” section of
the on-screen display menu to select
the desired aspect ratio.
17 D.ZOOM + Zoom in the projector display.
18 INFORMA-
TION
Display information menu.
 To quick change
remote control code,
press “MENU” and
“IMAGE” buttons
about 10 seconds at the
same time.
Note