Samsung AD68-04519A - Manual (Page 33)

33
Optical Image Stabilization (OIS )
Use the optical image stabilization (OIS)
function when taking pictures to minimize
camera shake and improve focus.
Using the OIS switch of lens
The OIS function can be used only in the case
that the lens in use has the OIS function.
To use this function, please set [OIS] to ON.
Using the OIS in the menu option
After setting the OIS switch, select the OIS
function in the menu option
1
In Shooting mode, press [MENU].
2 Select Shooting3 (
3
/
3
) OIS
an option.
OIS
Mode 1
The OIS function is applied only when
pressing the shutter in full or half.
OIS
Mode 2 The OIS function is always applied.
ON
OIS
OFF
The OIS function may not work well in the •
following situations:
When you take a picture while tracing a -
moving object
When a big vibration occurs beyond the
-
range of stabilization
When the shutter speed is too slow due to a
-
circumstance like night shooting
When the battery capacity is not suffi cient
-
When you are shooting a close-up shot -
When you use a tripod, please disable the OIS •
function since the image can be shaken due to
the vibration of OIS function.
If the camera is struck or dropped while you are
•
taking a picture, the display can be impaired.
If this occurs, turn the camera off and then on,
and the camera should operate normally again.
Since the battery consumption can increase
•
along with the use of OIS function, it is
recommended to use the function only if
needed.
To set the OIS function by using the menu,
•
set [OIS] of lens to ON. This function may not
operate depending on the lens model.
The function can be set directly by pressing [
• Fn]
in the shooting mode.