Sega WaveRunner GP User Manual

Page 87

www.seuservice.com

Loosen the 2 screws that secure the V.R. Bracket to move the V.R. Bracket.

Move the V. R. Bracket to disengage the Adjust Gear mesh and move the V.R. shaft so that the
cut part of the shaft may turn to the opposite side of the Adjuster Gear as shown.

Engage the gear and tighten the 2 screws.

Carefully turn the Handle Shaft to the left/right and ensure that the V.R. value variations are
within the range of the Volume.

After finishing adjustments, be sure to perform the Handlebars Volume Setting in the Test
Mode (see 9-3 e).

SCREW (2)M4 X 8,w/flat & spring washers

GEAR

V.R. BRACKET

V.R. SHAFT

ADJUST GEAR

FIG. 12. 2

Take out the 2 screws that secure the
Volume Bracket to remove the
Volume Bracket.

Remove the Volume Gear from the
V. R. to replace the V.R.

After the replacement, be sure to perform the Handlebars Volume Setting in the Test Mode
(see 9-3 e).

SCREW (2)
M4 X 8,w/flat & spring washers

HANDLE V.R.

220-5373,5484

PHOTO 12. 2 c

V. R. REPLACEMENT