Sega WaveRunner GP - Manual (Page 110)

www.seuservice.com 101
17 - 2 ERROR MESSAGE
This work should be performed by the Location's Maintenance Man or
Serviceman. Performing work by non-technical personnel can cause
accidents.
Should any errors other than listed by this manual or by NAOMI Service
Manual occur, contact where the product was purchased from or an office
described in this manual. Failing to comply with this instruction can cause
accidents.
This product displays the error on the screen if the faulty is detected. If an error is displayed, be
sure to take action against it according to the appropriate cause and countermeasures listed
below.
It may be displayed the error other than listed by this manual or by NAOMI Service Manual. In
that case, contact where the product was purchased from or an office described in this manual
without operating it selfishly.
DISPLAY NETWORK ERROR: NO MASTER SITE
CAUSE No MASTER setting in Communication Mode.
COUNTERMEASURES Perform the Communication Mode setting in the Game Assign-
ments. Set one of the machines to MASTER and all others to
SLAVE. (9-3 d) (20-3)
DISPLAY NETWORK ERROR: DUPLICATE MASTER SITE
CAUSE MASTER setting is duplicated in Communication Mode.
COUNTERMEASURES Perform the Communication Mode setting in the Game Assign-
ments. Set one of the machines to MASTER and all others to
SLAVE.
DISPLAY NETWORK ERROR: NO SLAVE SITE
CAUSE No SLAVE setting in Communication Mode.
COUNTERMEASURES Perform the Communication Mode setting in the Game Assign-
ments. Set one of the machines to MASTER and all others to
SLAVE. (9-3 d) (20-3)
DISPLAY NETWORK ERROR: TOO MANY NODES SITE
CAUSE Too many machines are connected.
COUNTERMEASURES Up to 4 machines can be connected to allow to enjoy communica-
tion play.
DISPLAY NETWORK ERROR: DUPLICATE CABINET ID
CAUSE The number of Cabinet ID is duplicated in Communication Mode.
COUNTERMEASURES Change the number of Cabinet ID for every seat in the Game As-
signments. (9-3 d) (20-3)
DISPLAY DRIVE BD ERROR: E2H
CAUSE The Ride is not centering with the right value.
COUNTERMEASURES Ensure that the Ride is slanted or the connector of ASSY Wire
Tube is connected securely. (Section 6)