Sanyo PJ LINK PLC-XU106 - Manual (Page 67)

6
The image is distorted or runs off . – Check PC adjustment Menu or Screen and adjust them.
See pages 33-34, 37-38.
PIN code dialog box appears – PIN code lock is being set. Enter a PIN code (the “1234” or numbers
at start-up . you have set). See pages 20, 55-56.
The Remote Control does – Check the batteries.
not work . – Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. See page 54.
– Unlock the Key lock function for the remote control function. See
page 55.
Indicator blinks or lights . – Check the status of the projector with referring to "Indicators and
projector Condition". See page 71.
The exclamation mark appears – Your operation is invalid. Operate correctly.
on the screen .
Top control does not work . – The top control is not available if the top control is locked at Key lock
under Security of SETTING section. See page 55.
Unable to unlock the Logo PIN – Contact the dealer where you purchased the projector or the service
code lock, Security key lock center.
or Security PIN code lock .
Appendix