Sanyo PJ LINK PLC-XU106 - Manual (Page 10)

10
Rear Terminal
⑥
S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.16).
⑨
AUDIO IN
Connect the audio output signal from video
equipment connected to
⑥ or ⑩ to this jack.
For a mono audio signal (a single audio jack),
connect it to the L (MONO) jack (p.16).
⑧
COMPUTER 1 (COMPONENT) / COMPUTER
AUDIO IN
Connect the audio output (stereo) from a
computer or video equipment connected to
②
or
④ to this jack (pp.15,17).
⑩
VIDEO IN
Connect the composite video output signal to
this jack (p.16).
②
COMPUTER IN 1 / COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal (pp.15,17).
⑦ AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.15-17).
This terminal outputs sound from AUDIO IN
terminal (
⑧ or ⑨).
⑤
LAN Connection Terminal
Connect the LAN cable (refer to the owner’s manual
of "Network Set-up and Operation").
⑥ ⑩ ⑦ ⑨
① CONTROL PORT
When the projector is controlled by a computer,
connect to this jack with serial control cable.
④
COMPUTER IN
Connect computer output to this terminal (p.15).
⑧
Part Names and Functions
③
MONITOR OUT
This terminal can be used to output the incoming
RGB signal from COMPUTER IN 1/COMPONENT
IN terminal or COMPUTER IN 2 to the other monitor
(pp.15,17).
② ③ ① ④ ⑤