Speco Technologies SIPSD37X - Manual (Page 41)

37X Speed Dome Camera 41/50
Group Setup
GROUP SETUP
------------------------
GROUP NO. 1
UNDEFINED
CLEAR GROUP CANCEL
RUN GROUP
BACK
EXIT
‰
Group Edit
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE
CANCEL [NEAR:EDIT]
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE [NEAR:EDIT ACT]
CANCEL [FAR :EDIT END]
z Group Number [1~8]
Selects a Group number to edit.
If the selected Group number is not
defined, "UNDEFINED" will be
displayed under the selected Group
number.
z Clear Group [CANCEL/OK]
Deletes the data of the selected Group.
z Run Group Runs the Group for the test purposes to
check if it works properly.
z Edit Group Edit the selected Group.
① Press Near key when the cursor is at “NO” to start
editing the selected Group.
②
Note that MAX. 20 actions are allowed in a Group. Move
the cursor up/down to select an Action. Press Near key
to edit.
OSD MENU 4