Smart Technologies 480i5 - Manual (Page 62)

USB Control settings
This menu contains settings that are applicable only to SMART Board interactive whiteboard
systems with ECPs.
Submenu setting Description
USB1 Source This setting is applicable only to SMART Board interactive
whiteboard systems with ECPs.
USB2 Source This setting is applicable only to SMART Board interactive
whiteboard systems with ECPs.
Network settings
This menu allows you to use or not use Dynamic Host Control Protocol (DHCP) and to set the
network-related addresses and names when DHCP is not used.
Submenu setting Description
DHCP Determines if the projector’s IP address and other network settings
are dynamically assigned by a DHCP server or manually set.
l
On allows the network’s DHCP server to assign a dynamic IP
address to the projector.
l
Off allows you to manually set the projector’s IP address and
other network settings.
IP Address Displays or allows you to set the projector’s IP address in values
between 0.0.0.0 and 255.255.255.255.
Subnet Mask Displays or allows you to set the projector’s subnet mask number in
values between 0.0.0.0 and 255.255.255.255.
Gateway Displays or allows you to set the projector’s default network gateway
in values between 0.0.0.0 and 255.255.255.255.
DNS Displays or allows you to set the projector’s IP address for your
network’s primary domain name server in values between 0.0.0.0 and
255.255.255.255.
Group Name Displays or allows you to set the projector’s workgroup name
(maximum 12 characters).
Projector Name Displays or allows you to set the projector’s name (maximum 12
characters).
Location Displays or allows you to set the projector’s location (maximum 16
characters).
Contact Displays or allows you to set the contact name or number for projector
support (maximum 16 characters).
SNMP Turns the Simple Network Management Protocol (SNMP) agent on or
off.
A P P E N D I X A
Remotely managing your system through a network interface
52