Smart Technologies 480i5 - Manual (Page 26)

Setting Use Notes
Set to Default? Resets projector settings to their
default values. If you select Yes, all projector settings
reset to their defaults, reversing any
menu changes you made. This action
is irreversible.
Don’t adjust this setting unless you
want to reset all of the applied settings,
or unless you’re advised to by a
SMART Support specialist.
USB1 Source N/A This setting is applicable only to
SMART Board interactive whiteboard
systems with Extended Control Panels
(ECPs).
USB2 Source N/A This setting is applicable only to
SMART Board interactive whiteboard
systems with ECPs.
Network menu
Network and VGA
Out Activates the projector’s VGA Out and
RJ45 connector and network features.
Status Displays the current network status
(Connected, Disconnected or Off). The default is off.
DHCP Displays the status of the network’s
Dynamic Host Configuration Protocol
(DHCP) as On or Off. The default is on.
On enables a DHCP server on the
network to automatically assign an IP
address to the projector.
Off enables an administrator to assign
an IP address manually.
Password
Reminder E-mails the network password to the
predefined e-mail recipient. See Web page management on page
47 to set up a destination e-mail
address.
IP Address Displays the projector’s current IP
address in values between 0.0.0.0 and
255.255.255.255. To change the projector’s IP address,
use the RS-232 connector (see
Network controls on page 66) or use a
DHCP server to assign a dynamic IP
address, and then set a static IP
address using the network remote
management feature (see Remotely
managing your system through a
network interface on page 47).
Subnet Mask Displays the projector’s subnet mask
number in values between 0.0.0.0 and
255.255.255.255.
C H A P T E R 3
Using your interactive whiteboard system
16