Star Micronics HL 80825321 - Manual (Page 30)

19
❏ Install the paper guide so that it lays down flat as
shown below. In this position, the paper guide
keeps the printed paper separate from the
unprinted paper
❏ Turn on the printer.
The printer will beep a number of times to
indicate that paper is not loaded properly. Also,
the control panel’s
POWER indicator flashes
whenever paper is not loaded.
❏ Pull the bail lever toward the front of the printer.
This will feed the paper to the starting position.
❏ After the paper is fully fed (indicated by the
printer’s beeping), return the bail lever back to its
original position toward the back of the printer.
Printing on fanfold paper
When printing on fanfold paper, take care not to print
too close to the perforations that separate each sheet.
The following shows the recommended print area for
fanfold paper and cut-sheet paper.
Important!
Never return the bail lever back to its original
position until the paper is fully fed. The printer will
beep to let you know when you can return the bail
lever to its original position.
Paper guide
Guide-papier
Papierführung
Guida della carta
LOAD
Bail lever
Levier du presse-papier
Freigabehebel
Leva libera-carta
Fanfold forms
Papier continu
Endlospapier
Modulo continuo Single sheets
Feuilles séparées
Einzelblatt
Fogli singoli
18 mm
(0.71") 18 mm
(0.71")
22 mm (0.87")
25.4 mm (1.00")
25.4 mm (1.00")
70 mm (2.76")
Perforation
Perforation
Perforation
Perforazione
21 mm (0.83")
22 mm (0.87")
5 mm
(0.20") 5 mm
(0.20")