Sharp Z-336J - Manual (Page 60)

7-26
Chapter 7: Computer Link Function
7
6 6 6 6 6 Write network parameters
This is a function used to change the network parameter data of a receiving node through the
network.
The following data can be changed.
- Node name (facility name)
- Address and size of common memory
When the address and size of the common memory is changed, the receiving node leaves the
network and re-enters it again. If only the node name is changed, the receiving node will not
leave the network.
Request message
Response message
Network parameter
Node number
Vender name
Manufacturer model name
Node name (facility name)
Top address of area 1
Size of area 1
Top address of area 2
Size of area 2
Token monitor time out time
Minimum allowable distance of frames
FL-net status
Protocol version
Upper layer status
Refresh cycle allowable interval RTC set value
Refresh cycle measured value (current value)
Refresh cycle measured value (maximum value)
Refresh cycle measured value (minimum value)