Sharp Z-336J - Manual (Page 201)

15-47
Chapter 15: Appendix
15
2. Insert a shield crimping pin into the tap case.
3. Tighten the case screw so that it will not loosen.
4. Place the tap case at one of the markers located every 2.5 m on the coaxial cable. Insert a frame
into the slide and secure the case using the screw. (Tighten the screw so that distance between
top of the tap case and holding metal is approximately 1 mm.)
Transceiver tap frame and tap installation device.
Center of the 2.5 m mark