Star Micronics SP200F - Manual (Page 19)

– 16 –
ENGLISH
5. Control Panel
5-1. Basic Operation
1 ON LINE switch
Switches the printer between ON
LINE and OFF LINE. ON LINE
and OFF LINE switching is possi-
ble only when paper is loaded in the
printer.
2 FEED switch
• When this switch is pressed and
then released within 0.5 sec., the
paper feeds on line.
• When this switch is held depressed
for more than 0.5 sec., the paper
feeds continuously.
(The above paper feed operation is
possible for both ON LINE and OFF
LINE modes.)
3 POWER lamp (green LED)
• Lights when the power to the printer is on.
• Flashes when paper is out, mechanical error occurs, when there is an alarm due
to head temperature detection, or when a CPU error has occurred.
• If the paper is out, load new paper and press the ON LINE switch.
• When the POWER lamp flashes due to occurrence of a mechanical error, turn
off the power and remove the cause of a mechanical error and then turn on the
power again to reset the printer.
• If the POWER lamp flashes due to the alarm of the head temperature detection,
the printer will be set automatically when the head temperature becomes low.
4 ON LINE lamp (green LED)
LED lit: Printer is ON LINE
LED off: Printer is OFF LINE
LED flashes: CPU error
When the POWER lamp and ON LINE lamp light simultaneously, a CPU
error has occurred.
ON LINE POWER FEED
3 4 1 2
Fig. 5-1 Control panel