Sharp XL-MP150 - Manual (Page 31)

31
XL-MP150
Tape Recording
Sequential recording from several discs:
To perform programmed recording:
To stop recording:
Press the (TAPE ) button.
The disc and tape will stop.
Note:
To record on both sides, begin with side A. (If recording is started
from side B, the tape will not switch over to side A.)
Auto restart function:
If the recording side is switched from side A to B during recording,
the system will record the interrupted track on side B from its begin-
ning. The recording will be made without cutting the beginning of the
track on side B.
„ Recording from the radio
To interrupt recording:
Press the
button.
To resume recording, press the same recording button you pressed
in step 5. Other buttons do not allow resuming.
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise while recording an AM station, move the
AM loop antenna.
„ Erasing recorded tapes
1 Press the TAPE button.
2 Follow steps 2 - 5 in "Recording from the radio".
1 Perform steps 1 - 6 in "Recording from a CD or MP3/WMA disc"
on page 30.
2 Within 5 seconds, press the / ( ) button to record on side A,
or the ( ) button for side B.
1 Program discs and tracks (see pages 21).
2 Press the
button.
3 Press the / ( ) button to record on side A, or the ( ) button
for side B.
1 Tune in to the desired station (see page 26).
2 Load a cassette into the cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3 Press the button to choose one side or both sides.
... To record on both sides.
... To record on only one
side.
4 Press the button.
Recording will be paused.
5 Press the / ( ) button to record on side A, or the ( )
button for side B.
To record on both sides, begin with side A. (If recording is start-
ed from side B, the tape will not switch over to side A.)