Sharp XL-MP150 - Manual (Page 28)

28
XL-MP150
Tape Playback
Listening to a cassette tape
„ Tape playback
Auto power on function:
When you press any of the following buttons, the unit turns on.
z TAPE button (main unit and remote control): The unit turns on and
the "TAPE" function is activated.
z TAPE button on the remote control: The unit turns on and side
A playback starts (regardless of the last function).
z / button on the main unit: The unit turns on and playback of
the last function starts (CD,TAPE,TUNER,VIDEO/AUX).
Auto power off function:
In the stop mode of tape operation, the main unit enters the stand-by
mode after 15 minutes of inactivity.
Before playback:
z For playback, use normal or low-noise tapes for
the best sound. (Metal or CrO tapes are not rec-
ommended.)
z Do not use C-120 tapes or poor-quality tapes, as
they may cause malfunctions.
z Before loading a tape into the cassette compartment,
tighten the slack with a pen or a pencil.
X-BASS (SURROUND) /DEMO
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TAPE button.
3 Open the cassette door by push-
ing the area marked " PUSH
EJECT".
4 Load a cassette into the cas-
sette compartment with side A
facing you.
5 Press the button to choose
one side or both sides.
... To listen to both sides.
To play both sides (
), start from side A. When play-
back starts from side B, side A will not be played.
... For endless repeat play of both sides.
... To listen to one side.
6 Press the / ( ) button to listen to side A, or the ( )
button for side B.
Forward play Reverse play