Sharp XL-MP150 - Manual (Page 14)

14
XL-MP150
Basic Operation
General control
„ To turn the power on
Press the ON/STAND-BY button to turn the power on.
„ Illumination light control
When the power is turned on, light illuminates around the display.
To turn on/off the light, hold down the CLEAR/DIMMER button on
the remote control for 2 seconds or more.
„ Speaker light up control
The speaker will light up according to the base level of the music
source played back. To turn on/off the light, hold down the CLEAR/
DIMMER button on the remote control for 2 seconds or more.
„ Volume auto fade-in
If you turn off and on the main unit with the volume set to 27 or
higher, the volume starts at 16 and fades in to the last set level.
„ Volume control
Main unit operation:
When the VOLUME control is turned clockwise, the volume will
increase. When it is turned counterclockwise, the volume will
decrease.
Remote control operation:
Press the VOLUME (+ or -) button to increase or decrease the volume.
„ Surround mode
When the X-BASS (SURROUND)/DEMO [X-BASS (SURROUND)]
button is pressed, the unit will enter the surround mode and adjust
low bass and high frequency automatically according to volume
input. To cancel this mode, press the X-BASS (SURROUND)/
DEMO [X-BASS (SURROUND)] button again.
„ Equalizer
When the EQUALIZER (EQUALIZER MODE) button is pressed, the
current mode setting will be displayed. To change to a different
mode, press the EQUALIZER (EQUALIZER MODE) button repeat-
edly until the desired sound mode appears.
Note:
If the EQUALIZER (EQUALIZER MODE) button is pressed in the
surround mode, it will be canceled automatically.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
30 MAXIMUM 0 .....
ROCK For rock music.
FLAT No equalization.
CLASSIC For classical music.
POPS For pop music.
JAZZ For jazz.
VOCAL Vocals are enhanced.