Philips Saeco Modular LUXE CAP001/A - Manual (Page 20)

English
20
fig. 15
7
B
fig. 14
7
A
fig. 16
fig. 17
fig. 18
C
D
C
C
C
E
It will then be necessary to open the coffee grinder unit (ref. 19,
fig. 1) and remove the cause of the jamming.
Danger
Disconnect the machine from the mains by way of the all-pole
switch or disconnecting the plug, and wait for machine to be
completely cooled off.
7.3.1 Coffee grinder
dismantling/assembly
In order to dismantle the coffee grinder the following steps must be
followed:
- Dismantle both side panels and the cup heating plate (see
“6.16 . Dismantling/assembly of panels”).
Danger of burns
Avoid contact with machine parts that might still be hot.
- Close the stop slide (ref. A, fig. 14) of the coffee bean hopper
(ref. 7, fig. 14).
- Remove the screws (ref. B, fig. 15) from the hopper (ref. 7,
fig. 15), and then slide this out of the machine by rotating it
slightly upwards from the back.
- With the help of a vacuum cleaner remove the beans from the
grinder’s inlet (fig. 16).
- Firstly remove the four screws (ref. C, fig. 17), then the geared
wheel (ref. D, fig. 17).
- Completely unscrew the adjustment ring nut (ref. E, fig. 18)
and clean both the grinders using a vacuum cleaner and a
brush.
Important
Verify furthermore the wear of the grinders as well as any dam-
age they might have suffered and, if necessary, replace them.