Sherwood RD-8601 - Manual (Page 15)

VCR VCR
CH.SEL CH.SEL T/V T/V
MUTE MUTE CH/LEVEL CH/LEVEL
MENU MENU SETUP SETUP
T.TONE .TONE OSD OSD
SLEEP SLEEP
AUTO AUTO
ADJUST ADJUST SPK SET SPK SET
1 2 3 4
8 7 6 5
9
M1 M2 M3
0 +10 +10
MACRO MACRO
PARAMA ARAMATER
DSP DSP STEREO STEREO
ENTER ENTER
DIMMER DIMMER
DISPLA DISPLAY
DVD SAT CBL
CD AUX TV
ST STANDBY ANDBY
TUNE TUNE
PRESET PRESET PRESET PRESET P.SCAN .SCAN
TUNE TUNE RETURN
POWER ON POWER ON
REMOTE CONTROL RNC REMOTE CONTROL RNC-50A 50A
DEVICE SELECT
VOLUME
TUNER CD AUX TAPE
VIDEO 1 VIDEO 2 VIDEO 3
EXT. IN
AUD
7m
30 30
REMOTE
SENSOR
SURROUND MODE INPUT SELECTOR STEREO AUTO
MASTER VOLUME
ON/STANDBY
POWER
STANDBY
ON/ OFF
TUNING/PRESET ADJUST PHONES CHANNEL SELECTOR
VIDEO L - AUDIO - R
VIDEO 3 BAND FM MODE T/P MODE TONE MODE SPEAKER SETUP DYNAMIC RANGE MEMO/ENTER CINEMA EQ
ON/OFF
SPEAKER
DSP MODE DIGITAL
INPUTS
AUDIO/VIDEO RECEIVER RD-8601
VIDEO AUDIO EXTERNAL IN PARAMETER
15
LOADING BATTERIES
REMOTE CONTROL OPERATION RANGE
1 2
• Use the remote control unit within a range of
about 7 meters (23 feet) and angles of up to 30
degrees aiming at the remote sensor.
OPERATING COMPONENTS WITH REMOTE CONTROL
• Remove the batteries when they are not used for a
long time.
• Do not use the rechargeable batteries(Ni-Cd type).
• Be sure to use alkaline batteries.
Remove the cover. Load two batteries(“AAA” size) matching
the polarity.
1
Enter the setup code for each component
other than this receiver you wish to
control. For details, refer to “Entering a
setup code” on page 16.
2
Turn on the component you want to
operate.
3
Press the DEVICE button on the remote
control corresponding to the component
you wish to operate.
4
Aim the remote control at the REMOTE
SENSOR of the component you wish to
control and press the button corresponding
to the operation you want.
• When operating a Sherwood CD player or tape deck
using digi link system remote control, aim the remote
control at the REMOTE SENSOR of this receiver.
However, to operate a Sherwood DVD player, aim at
the REMOTE SENSOR of the corresponding
component.
• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within several
minutes after removing old batteries.
• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared. Should
this happen, you should memorize them again.
+
+
ENGLISH