Sanyo VCC-MC600P - Manual (Page 16)

Camera Settings (CAMERA)
15
4 Use the joystick lever (xy) to select a zone to be
weighted and use the lever (vw) to adjust
weighting.
Selecting a zone to be weighted shows the corresponding
zone on the screen.
Available settings: 0 - 7 (The larger the number, the higher
the weighting.)
☞
After completing setting, use the lever to move the cursor to
[MENU] and select “BACK” or “END”.
b Multi-spot metering (MASK)
Sets backlight compensation by masking the bright area of the
background using mask patterns.
1 Use the joystick lever (xy) to select [BLC], use the
lever (vw) to select “MASK y”, and press the
[ENTER] button.
The BLC MASKING screen appears. A mask pattern is
displayed in the top left of the screen.
2 Use the joystick lever (xy or vw) to move a mask
pattern to the area to be excluded in metering, and
press the [ENTER] button.
This sets the mask pattern for the area to be excluded in
metering.
If you want additional mask patterns to be set, repeat the
above procedure.
Use the joystick lever (xy or vw) to place a mask pattern over
the mask pattern to be cancelled, then press the [ENTER]
button.
3 Use the joystick lever (y) to move a mask pattern to
the bottom area of the screen and continue holding
the lever straight down for three seconds.
This completes the mask pattern setting procedure.
☞
After completing setting, use the lever to move the cursor to
[MENU] and select “BACK” or “END”.
• TOP • BOTTOM
• LEFT • RIGHT
• CENTER [FIX] (The value is fixed to “7”.)
The multi-spot metering (MASK) function is available
only when registering a view setting file in the CAMERA
VIEW screen (P27).
Set [MASKING] to “ON” in the MOTION SETTING screen.
BLC MASKING
CONTINUE (y)
Mask pattern
BLC MASKING
CONTINUE (y)
L5BU2_XE(VCC-MC600P_MC500P)(GB).book 15 ページ ２００７年１月１８日 木曜日 午前９時４４分