Shure LX88-II User Manual

Page 8

BODY-PACK TRANSMITTER SETUP
LX1 Body-Pack Transmitter Battery Installation (Figure 14)

БББ

FIGURE 14

LX1 BODY–PACK TRANSMITTER BATTERY INSTALLATION

БББ

1. With the transmitter POWER ON/OFF switch in the OFF position, press down

on the OPEN side of the battery compartment cover, slide it back and flip it open.

2. Insert a new 9V alkaline battery in the compartment (DURACELL MN1604

recommended). Observe proper battery polarity (“+/–”).

3. Close Battery compartment cover.

Operating LX1 Body-Pack Transmitters (Figure 15)

LX1 BODY–PACK SYSTEM SETUP AND OPERATION

FIGURE 15

LX88-

RECEIVER

ББ

LAVALIER

MIC

WA302 INSTRUMENT

ADAPTER CABLE

WM98 MIC

& A98KCS

HORN MOUNT

WH10

HEADSET

NOTE: The LX1 body-pack system is designed for use with other equipment
which is not included, such as lavalier microphones, guitars, headset micro-
phones, etc. See your Shure dealer for details on ordering the proper equip-
ment for your needs.

1. Clip the LX1 body pack transmitter to your belt or guitar strap.

2. Connect the lavalier microphone, headset or instrument adapter cable to the

body–pack transmitter (Figure 16).

3. Press the POWER button on the LX88-

receiver ON.

4. Turn the transmitter POWER switch ON.

Check Power/Battery fuel gauge.

5. Check the RF Signal Indicator on the LX88-

receiver to see if the RF

signal is being received.

MICROPHONE CABLE OR

WA302 INSTRUMENT ADAPTER

CABLE

LX1 BODY-PACK TRANSMITTER CABLE CONNECTION

FIGURE 16

ББББ

ББ

ББББ

БББ

ББББ

ББ

БББ

ББ

ББББ

ББ

БББББ

6. Slide the transmitter ON/MUTE switch to the ON position and begin speaking

or playing your instrument.

NOTE: If the red PEAK light on the receiver does not flicker during the loud-
est sounds, the transmitter gain may need to be increased. See the

Trans-

mitter Audio Gain Adjustment section.

7. During the performance or presentation, slide the ON/MUTE switch to the

MUTE position when the system is not being used.

8. When the performance or presentation is over, slide the transmitter POWER

ON/OFF switch to the OFF position to conserve battery power.